Cabletron Systems CyberSWITCH CSX150, Руководство пользователя

Страница: 347 / 620

Small Office Remote Access Switch 347
S
YSTEM
V
ERIFICATION
Verifying IP Routing Over Interfaces
If the remote IP host successfully pings to the local IP host, then IP routing over the WAN
Remote LAN interface is operational. Repeat the above steps for each WAN Remote LAN
interface through which you wish to get access.
If the remote IP host CANNOT ping to the local IP host, refer to IP Routing over a WAN Remote
LAN Interface Connection in the Problem Diagnosis chapter.
V
ERIFYING
IP R
OUTING
O
VER A
WAN U
N
N
UMBERED
I
NTERFACE
To verify that IP routing is properly operational over a WAN UnNumbered interface, the
CyberSWITCH must be operational and available to initiate connections.
Below is an example of a configuration used to verify IP routing over a WAN UnNumbered
interface. It uses IP addresses specific to the example. Substitute the IP addresses of your network
when you perform the IP routing verification steps. It also uses the “ping” command. The “ping”
command sends a packet to a specified host, waits for a response, and reports success or failure.
The steps to verify the operation of IP routing over a WAN UnNumbered interface are:
1. Determine if SITE1 can access SITE2 over the WAN connection. On system A type:
ip ping 192.1.0.2
<return>
If the ping is successful, then continue with the next step.
If system A CANNOT ping to system B, refer to IP Routing over a WAN UnNumbered Interface
Connection in the Problem Diagnosis chapter.
2. Determine if system B can access system A over the WAN connection. On system B type:
ip ping 100.0.0.1
<return>
If the ping is successful, continue with the next step.
If the system B CANNOT ping to system A, refer to IP Routing over a WAN UnNumbered
Interface Connection in the Problem Diagnosis chapter.
"SITE1"
"SITE2"
100.0.0.1 192.1.0.2
ISDN
CSX150 CSX150