CAB Hermes C 6L, Руководство по обслуживанию

Страница: 30 / 36

30 30 5 Adjustments
5.7 Adjusting the Ribbon Saver
The ribbon saver reduces the consumption of transfer ribbon amongst others by lifting the printhead while feeding
blank label areas. The printhead will be lifted by eccentrics (6) which are controlled by a clock wheel (3) and an
optical sensor (4).
A misaligned clock wheel can cause a reduction of the saver effect in the saver phase or a deterioration of the print
image and a stagnant ribbon transport in the print phase.
Danger!
Risk of death via electric shock!

Before opening the housing cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
Ribbon saver - main color
1 2 3a 4 5 6 1 3b 4 5 6
Ribbon saver - additional color
1 4 3a 2 5 6 3b 4 5 6 1
Figure 31 Position of eccentrics and clock wheel
in the saver phase
Figure 32 Position of eccentrics and clock wheel
in the print phase
7
5
6
8
7
5
6
1. Unplug the printer from the electrical outlet.
2. Remove the rear cover.
3. Turn lever (7) clockwise to lock the printhead.
4. Loosen the screws (2) at the clock wheel.
5. Turn axle (1) in such a way that the eccentrics (6)
lift the printhead via the ball bearings (5) at most

Figure 31 right side.
6.
Align the flange (3a) to the edge of the sensor
housing (4) by turning the clock wheel

Figure 31 left side.
7. Tighten screws (2).
8.
Turn axle (1) and align the flange (3b) to the other
edge of the sensor housing

Figure 32 left side.
9. Check the distance between ball bearing (5) and
eccentric (6) with the 0,1 mm gauge (8).
10. Mount the rear cover.
Figure 33 Checking the distance ball bearing - eccentric