20
cab Produkttechnik GmbH & Co KG
8
1
12
11
Figure 6 b Media Loading - Part 2
7. Continue feeding the label strip between the tear/peel plate (
12
) and the
thermal printhead (
8
) as shown in Figure 6b.
Batch Mode Loading and Demand Mode with Tear-Off Loading
8. Route the media strip forward straight through the front of the printer as
shown in Figure 6a.
9. Check the position of the media guide (
6
) and if necessary, slide it inward
until it lightly touches the sides of the media strip.
10. Adjust the media roll to remove any slack, then lower the printhead by
rotating the printhead lever (
1
) counterclockwise until it stops.
Make sure that the dispenser locking roller (
10
) is open. This helps to keep
the wear at the roller low.
10
9
6
F
