12
12
4
Loading Material
Load transfer ribbon and endless material as described in the Operator's
Manual of the printer
Use the tear-off mode information for loading endless material for cut
mode.
Place the media strip between the printhead and the drive roller, so that
the front edge of the strip reaches through the cutter.
5
Operation
5.1 Standard Operation
The printer is ready for operation when all connections have been made and
all materials are loaded correctly.
i
Notice!
To operate the cutter with continuous material in the printer
menu „Setup“ -> „Print parameters“ -> „Label sensor“ the setting
„Endless media“ has to be selected. Otherwise no synchronization
cut is carried out.
Switch on the printer.
The cutter performs a cut.
Press the feed key. For synchronization the media will be moved forward
and cut off.
Printers synchronization is not necessary when the printhead was not
opened between print jobs, even if the printer was powered off between
print jobs.
Activate the cut mode in the software.
For direct programming use the C-command (
Programming Manual).
Send a print job.
All labels in the job will be printed without stopping and be cut as chosen in
the software : after each label, after a specific quantity of labels, or at the
end of a print job.
