15
5.2
Adjusting the Transport Rollers
4
4
3
3
1
2
Figure 15
Adjusting the transport rollers
The transport rollers (3) can be shifted on the axles (1).
Loosen the screws (3).
Set the transport rollers in such a way that
•
the tubes to be labeled are guided over the longest possible length and
•
the top edges of the transports rollers are below the thread or cap (2) of the tube respectively the area over the
transport rollers is long enough to insert and remove the tubes.
Tighten the screws (3).
5.3
Adjusting the Pressure Roller
2
1
3
Figure 16
Adjusting the pressure roller
The pressure roller (1) can be shifted on the axle (3).
Loosen the screw (3).
Set the pressure roller in such a way, that the roller can grasp the tube in the middle.
Tighten the screw (3).
