13
6
Error Messages
6.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.) "
Operator's manual" of the printer
Error treatment:
Clear the error result
Press the
feed
key to synchronize the label feed, remove the excess labels manually
Press the
pause
key to quit the error state.
After error correction, the printing of the label causing the error will be repeated.
6.2
Error Messages of the Applicator
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problems:
Error Message
Possible Cause
Vac. plate empty
Label has been removed from the waiting position at the pinch roller before the START
signal was initiated.
Upper position
The label had not arrived the sensor area 5 sec. after it was printed or it was not
detected.
Table 3
Error messages of the applicator
Error treatment:
Clear the error results
Press the
pause
key to quit the error state.
i
Note!
In the case of errors check the Service Manual for adjustments and settings.
After error correction, the print of the label causing the error cannot be repeated without re-start of the print job.
Except at the error "
Vac. plate empty"
.
In this case, the latest label will print again after quit the error with the
pause
key and then press the Enter button .
In the application mode "Apply/Print" send the signal "Print first label" or press the button
to send a printed
label to the tamp.
