15
5.4
Mounting the applicator
!
Attention!
Disconnect the printer from the power supply before mounting the applicator!
Ensure a stable positioning of the printer!
Connect the compressed air only after mounting the applicator to the printer!
1
1
2
2
6
7
3
4
5
1. Hang the applicator to the printer via the female
hinges (1) to the male hinges (2) of the printer.
2. Connect the SUB-D 15 male connector (6) to the
female connector (7) of the printer.
3. To ensure the applicator does not slip out of the
hinges, loosen screw (4), move the locking plate
(3) to secure the applicator and tighten screw (4)
again.
4. When pivoting the applicator onto the printer
ensure that the cable is not caught between the
two units.
5. Tighten the thumbscrew (5).
6. Raise the stopper on the rail to enable movement
of the lifting cylinder.
„6.5 Transportation Lock“
Fig. 9
Mounting the applicator to the printer
5.5
Transportation lock
1
3
2
1
3
2
4
3
Fig. 10
Stopper as transport lock
When the applicator is delivered, the stopper (2) is mounted on the rod (1). With this stopper (2) the labelling position
for the operation mode "Blow on" can be adjusted.
In transit the stopper (2) is used as a transport lock.
i
Note!
To reduce the impact energy it is possible to use a stopper with cushion (4).
Lifting the transport lock
1. Loosen screw (3) at the stopper (2).
2. Move the stopper (2) along the rod (1) into the position as in the operation mode.
-
Operation mode "Blow":
„6.8 Adjusting the Options for Movement in Direction Z“
-
Operation mode "Stamp on": Move the stopper (2) up to the end of the rod (1).
3.
Tighten screw (3) to fix the stopper (2) in position.