CAB 3014, Руководство по обслуживанию

Страница: 26 / 33

26 26
8.3 Application mode
Labeling the front side, in direction of the transport
- Label will printed and takeover of the applicator.
- Pad is swinging in the labeling position (1 and 2).
- Product touched the pad and will detect over the product sensor. Figure - section 2 and 3
- Vacuum will switched off and the label will apply (stamp on or blow on). Figure - section 3
- Pad moves back to the start or takeover position (printer to applicator) Figure - section 4
1 2 3 4
Fig. 20 Labeling Front Side
Labeling rear side, in direction of the transport
Setup settings:
Operation Mode > Stamp on
Parameters, such as mode and waiting position are set automatically.
Operation Mode > Blow
Set parameters, such as mode and waiting position as follows!
Mode of appl. > Apply-Print
Waiting position > up
- Pad is waiting in start position. Figure - section 1
- A signal of an external sensor, initialize by the product will start the labeling process. Figure - section 1
- Pad will swinging behind the product and apply the label. Figure - section 2 and 3
- It will start the movement return to the start position (4).
1 2 3 4
external sensor
Fig. 21 Labeling Rear Side
8.4 External Sensor for Labeling Rear Side
Circuit of the 3 pole connector on the applicator. This is connected to CON 6 on the PCB applicator control.
26.01.2016 09:31 f=0.81 N:\LPeagle\5955578_i05 Etikettiereranschlüsse \5955578_i05.sch (Sheet: 1/1)
signal
start signal: high.
Fig. 22 Connector circuit
8 Operation