7
4
Operation
4.1
Setting the Rewind Direction
!
Attention!
Risk of damage !
Do not change the rewinding direction, when the rewind axle is turning.
1
Set the switch (1) to the intended rewind direction.
Rewinding with labels inside
Rewinding with labels outside
Figure 3 Setting the rewind direction
4.2
Rewinding directly onto the Rewind Axle
9
8
1
2
3
4
5
6
6
7
1
6
7
4
5
8
Figure 4 Rewinding directly onto the Rewind Axle
1. Loosen screws (2) and remove spring (3).
2. Feed the label strip over the guide bar (5) and under the roller (8) to the rewind axle (4). Ensure that the label strip
is even with the disc (1).
3. Attach the label strip to the rewind axle by setting the clamp (9) over the label strip in the groove of the rewind
axle (4). Consider the rewind direction :
- The full line is valid for outside wound labels.
- The broken line is valid for inside wound labels.
4. Slide the clamp (9) as far as possible towards the disc (1).
5. Slide the plate (7) onto the rewind axle so that it slightly touches the label strip. The label strip must be able to
move slightly between the disc and the plate.
6. Tighten the knurled screw (6).
The rewinder is ready for operation. If the printer carries out a paper feed the rewinder also starts to operate.
