C.P.Bourg Document Finisher E Series, Руководство оператора

Страница: 66 / 75

Operator Manual
Page 9 - 66
Initial issue: 02/13
Latest revision: -
10.5 4 - Remedies
a - Jam clearance
Any paper jam in the machine is indicated by an error message specifying the zone involved.
Note: After cleaning a jam, always verify that no paper pieces are left in the paper path.
As a general rule
Open the front doors or the upper cover and remove the sheets of paper from the
specified zones, refer to "Identification of the baffles", page 65
Close again the door.
If all zones are empties, the messages disappeared and the machine goes back to the
RUN menu.
b - Trim waste bin
Open both doors and empty the trim waste bin.
«Trim waste bin removed».
Put the trim waste bin back and close again the both doors.
« Start again the BDF».
Note: If error still present,- Check that the “Trim waste bin full” detection system is
cleared of paper cuts.- Call service engineer.
c - Element that has not reached its reference
- Do again a set-up (Go back to the Main Menu then to the Run Menu) and try to start again
the job.
- Shut down and start again the machine and try to start again the job.
Note: If the error is not eliminated, call for service.