WHITE POOL INSTRUCTION MANUAL
pag. 21 / 29
www.cpa-piscine.it
Rev.00
–
16/10/20
IX.
Measuring the pool wall
WARNING
A pool that is not level is very dangerous and may
collapse at any time.
Diagram 22
Diagram 23
Check the pool wall level by placing a length of timber beam or similar across the diameter of the pool wall and placing the builders
level on the top of the timber beam (see diagram 22). If the deviation is more than 2 cm (see diagram 23) then the ground site
must be levelled again. Check also if the pool is oval and measure the diameter across a few spots to make sure the differences
of each diameter measured are within 2cm.
If the levels are not to specification then the area will have to be leveled again.
WARNING
Try not to manage any of the components when dissembling the pool wall to correct the level of the ground.
Once the measurements and levels are correct and all nuts and bolts are tightened, then cover the exposed screw heads with the
self-adhesive tape (see diagram 24 and 25).
Diagram 24
Diagram 2
15
