C-Dax GoldLine Series, Руководство пользователя

Страница: 8 / 26

8
INSTALLATION
Pre Delivery Check
Remove shrink-wrap then check major components for missing or damaged parts (remove any contents from
inside tank before filling)
-
Frame (with linkage pins and clips)
- Tank
- Lid
- Filter
- Pump (Hose tails tight)
- Control unit and stand (clamps and hose tail tight) Gauge mount tight
- Drive shaft
- Suction filter (bowl tight)
- Check spray pump oil level in pump sight glass (¼
– ¾)
- Check spray pump accumulator pressure (0-2 bar boom spraying, 2-6 bar handgun spraying)
- Put water in tank (50-100 litres)
- Ensure filter valve is open
- Check for leaks in plumbing
- Connect drive shaft to pump. NB
Drive shaft length may need to be trimmed to suit client’s tractors
- If boom or hose reel is fitted, check mounting bolts for tightness
- Ensure control unit pressure control is wound fully out (CCW) and dump valve set to 0 (dump position)
- Run pump at 540 rpm
- Ensure fluid flows in return line to tank and that there are no leaks
- Turn lever on to I (pressure position)
- Set Control unit pressure to 3 bar (45 psi) (See operating section for further control unit instructions)
- Open valve to boom and allow fluid to flow until all air is expelled from spray line.
- Ensure all nozzles spray evenly and there are no leaks
- Shut off control unit valve and ensure all nozzles stop spraying and do not drip
Delivery
(Assuming above pre delivery check has been completed)
-
Fit sprayer to tractor
- Put water in tank (50-100 litres)
- Ensure filter valve is open
- Check for leaks in plumbing
-
Connect drive shaft to pump. NB
Drive shaft length may need to be trimmed to suit client’s tractor(s).
Keep universals within specification. I.e. 15 Degree angle
- Adjust top linkage length to level sprayer at normal operating height
- Ensure control unit pressure control is wound fully out (CCW) and dump valve set to 0 (dump position)
- Run pump at 540 rpm
- Ensure fluid flows in return line to tank and that there are no leaks
- Turn lever on to I (pressure position)
- Set Control unit pressure to 3 bar (45 psi) (See operating section for further control unit instructions)
- Open valve to boom or other spraying device, and allow fluid to flow until all air is expelled from spray line
- Ensure all nozzles spray evenly and there are no leaks
- Shut off control unit valve and ensure all nozzles stop spraying and do not drip