BZBGEAR BG-EXH-70C3
PRODUCT MANUAL
Operation Controls and Functions
T
RANSMITTER
P
ANEL
Name
Function Description
SERVICE
Firmware update port.
HDMI OUT
HDMI signal loop output port. Connect to the HDMI display devices using an HDMI cable.
HDMI IN
HDMI signal input port. Connect to the HDMI source device using an HDMI cable.
CAT OUT
RJ45 port to connect to the CAT IN port of the receiver using a CAT6/6a cable.
Link Signal
Indicator
(Green)
Solid: The transmitter and receiver have a good connection status.
Flashing: The transmitter and receiver have a poor connection status.
Dark: The transmitter and receiver are not connected.
Data Signal
Indicator
(Orange)
Solid: HDMI signal with HDCP.
Flashing: HDMI signal without HDCP.
Dark: No HDMI signal.
IR IN
Connect to the IR receiver cable. The IR receive signal will emit to the IR OUT port of the receiver.
IR OUT
Connect to the IR blaster cable. The IR will emit a signal from the IR IN port of the receiver.
DC 12V
DC 12V/1A power input port.
Note:
The extender supports PoC functionality. Either the transmitter or receiver must be connected to
a 24V/1A power supply. The other does not require a power supply.
EDID DIP
switch
Use the DIP switch to set EDID. Switching to the upper end indicates 1; switching to the lower end
indicates 0.
11 - EDID information is copied from the display at the RX. 10 - EDID is preset to 4K@60Hz Stereo
01 - EDID is preset to 1080p Stereo
00 - EDID information is copied from the HDMI OUT at the TX.
Address:
830 National Drive #140, Sacramento, CA 95834, USA
·
Tel:
+1(888)499-9906
·
Email:
7
