7
Rear Panel
①
VGA input 1 to 4--- VGA input 1 to 4 with L/R audio input.
②
L/R In 1 to 4--- Connect to addition audio input to embed to HDMI output 1 to 4.
③
AV input--- AV input with L/R audio input.
④
YPbPr input--- YPbPr input with L/R audio input.
⑤
TCP/IP---Connect to Ethernet for control.
⑥
RS232 port--- DB9 connector for local control only.
⑦
DIP switcher---EDID settings.
[DIP]=0000: HDMI 1080p@60Hz, Audio 2CH PCM
[DIP]=1111: Copy EDID from HDMI output, i.e., EDID pass through
[DIP]=0001: HDMI 1080p@60Hz, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=0010: HDMI 1080p@60Hz, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=0011: HDMI 1080i@60Hz, Audio 2CH PCM
[DIP]=0100: HDMI 1080i@60Hz, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=0101: HDMI 1080i@60Hz, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=0110: HDMI 1080p@60Hz/3D, Audio 2CH PCM
[DIP]=0111: HDMI 1080p@60Hz/3D, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=1000: HDMI 1080p@60Hz/3D, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=1001: HDMI 4K2K, Audio 2CH PCM
[DIP]=1010: HDMI 4K2K, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=1011: HDMI 4K2K, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=1100: DVI 1280x1024@60Hz, Audio None
[DIP]=1101: DVI 1920x1080@60Hz, Audio None
[DIP]=1110: DVI 1920x1200@60Hz, Audio None
⑧
IR RX---Connect to IR receiver cable.
⑨
IR TX--- Connect to IR emitter cable.
⑩
Phoenix terminal---Work with HDBT Transmitter / Receiver for RS232 pass through.
⑪
Ethernet port
—Connect to Ethernet. (
Embedded
Ethernet hub)
⑫
Ethernet port--- Connect to Ethernet port. (
Embedded
Ethernet hub)