BYD ECB16S-B, Руководство оператора

Страница: 31 / 43

TRANSPORTATION AND STORAGE
ECB16S-B/ECB18S-B 60
ECB16S-B/ECB18S-B
61 OM-ECB16/18S-B2019001-EN
2.Dual drive type
Gear Oil Replacement
1. Gear Oil Replacement (Dual Drive)
(1) Run the forklift until the driving axle gets lightly heated. Park the forklift on a level floor, apply
the hand brake, switch off the forklift, remove the key and press down the emergency disconnect
switch.
(2) Using a jack, raise the forklift. Put wedge blocks under other wheels to prevent unexpected
movement and remove the wheel.
(3) Clean the surrounding areas around the "Oil drain plug", "Oil filler plug" and "Oil dipstick plug".
Place a container below the "Oil drain plug".
(4) Remove "Oil drain plug", "Oil filler plug" and "Oil dipstick plug" and drain all the gear oil.
(5) Put the "Oil drain plug" back on and tighten it.
(6) Add the gear oil through oil filler hole until the gear oil overflows out of "Oil dipstick plug".
(7) Tighten both "Oil dipstick plug" and "Oil filler plug".
(8) Refit the wheel and replace the gear oil in the gear box on the other side.
11
11
CODE PART NAME QTY INFORMATION
11 FLUID DRAIN PLUG 1 20Nm
2.
Gear Oil Replacement (Single Drive)
Caution
(1) Make sure that the gear oil reaches the lower edge of the oil dipstick plug.
(2) Gear oil with specified type is allowed to use.
(3) The working temperature of gear box cannot exceed 120
°
C.
11
12
12
13
11
CODE PART NAME QTY INFORMATION
11 OIL DRAIN PLUG 1 20Nm
12 OIL FILLER PLUG 1 20Nm
13 OIL DIPSTICK PLUG 1 20Nm
1
2
3
CODE PART NAME QTY INFORMATION
1 OIL DRAIN PLUG 1
2 OIL DIPSTICK PLUG 1 60Nm
3
OIL FILLER PLUG
1 20Nm