BYD ECB16S-B, Руководство оператора

Страница: 25 / 43

TRANSPORTATION AND STORAGE
ECB16S-B/ECB18S-B 48
ECB16S-B/ECB18S-B
49 OM-ECB16/18S-B2019001-EN
DECOMMISSIONING AND RESTORING
Decommissioning
Clean and remove the dust on the forklift components and conduct the following procedures
：
(1) Check forklift for oil leakage and other abnormal components. If yes, repair the forklift
first.
(2) Fully lift and lower the forks and tilt masts several times. Operate the attachment several
times if there is an attachment.
(3) Lower the forks to a supporting surface so that the lifting chains will no longer be
tensioned.
(4) Apply paint to all areas where paint layer comes off.
(5) Check the hydraulic oil level and add if necessary.
(6) Lubricate all the components.
(7) Take off the key and make sure that forklift is disconnected from the battery power and
press down the emergency disconnect switch. Battery status of charge should be around
50% to avoid over-discharge or full charge for long-term storage.
(8) Lubricate the inside part of the hydraulic cylinders monthly by lifting/lowering the forks and
tilting mast several times. Operate the attachment several times if there is an attachment.
Caution
(1) When storing the forklift, place the forklift on a shelf so that the wheels are off the ground
to protect the wheels and wheel bearings.
(2) Do not cover the forklift with a plastic cover, which will cause water vapor to condense
and to accumulate.
(3) Ask your BYD dealer for advice if the forklift needs to be decommissioned for more than 6
months.
Restoring
Clean and remove the dust on the forklift components and conduct the following procedures
：
(1) Lubricate all the components.
(2) Fully lift and lower the forks and tilt masts several times. Operate the attachment some
times if there is an attachment.
(3) Check the status of charge of the traction battery.
(4) Check the gear oil. Replace it if necessary.
(5) Check the hydraulic oil. Replace it if necessary.
MAINTENANCE
This chapter explains how to maintain the forklift.
Caution
The operator should repeatedly check the performance of the forklift brake when operating it for
the fi rst time after the forklift has been restored to service.