82
A 2 Installation set for water softeners
The installation set complies with the requirements
of standard EN 1717.
►
If necessary, put the rubber sleeve (
1
) on the
DN40 pipe as shown.
►
Place the coupling nut with the sealing ring (
2
)
on the pipe and screw it to the siphon.
►Position the overflow hose connection (
3
) at least
20 mm below the height of the overflow point of
the water softener.
►
Route the rinsing water hose with an incline to the
connection (
4
) and push it in by 90 mm.
►Route the overflow hose from the regenerative
container to the connection (
1
), attach it and
secure it with a hose clamp.
NOTE
►
The flushing water and overflow hoses
must not be connected or constricted at
any point.
4
3
Rinsing water hose
Overflow hose
90 mm
90°
90°
2
1
Quantity Designation
1
Angle terminal strip for the rinsing
water hose
1
Snap-on hose clamp for attaching
the overflow hose to the container
with cylindrical nozzle
1
Wire tensioning clamp for attaching
the overflow hose to the container
with conical nozzle
4
Flat gaskets for corrugated hoses
DN 40
Building drainage
