PRODUCT INFORMATION
BULLETIN
238 Pillow Street
Butler, PA 16001
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
AIR-EAGLE
®
SR PLUS
2.4GHz 8 Input Transmitter
MODEL 36-1800-120VAC
Rev.3
DESCRIPTION
The A
IR
-E
AGLE
SR PLUS RF T
RANSMITTER IS
an eight input unit designed
to transmit unique signals to an Air-Eagle Receiver(s) located up to 1200
feet away. The Air-Eagle SR PLUS TX is user-programmable for up to
128 digital addresses and eight network frequencies to allow multiple
transceivers to operate simultaneously in the same area and utilizes
spread-spectrum technology and provides the utmost security and
reliability even in the noisiest RF environments. A terminal strip has been
provided for interfacing with external dry contact inputs. This unit can
operate remote machinery such as pumps, gates, chutes etc.
INSTALLATION
DISCONNECT AC Power from all equipment before installation.
1.
Mount the A
IR
-E
AGLE
SR PLUS T
RANSMITTER
in a convenient
location.
2.
Install antenna. The unit has an antenna connector located on the
right side on the enclosure. Attach the supplied portable antenna or
coax for external antenna to this connector.
3.
Connect AC power and control to the proper terminals in your control
circuit.
TERMINAL STRIP WIRING – BOTTOM PCB
1
N/O Input #1
7
N/O Input #4
2
C Input #1
8
C Input #4
3
N/O Input #2
9
120 VAC - (Neutral)
4
C Input #2
10
120 VAC - (Hot)
5
N/O Input #3
6
C Input #3
TERMINAL STRIP WIRING –TOP PCB
1
N/O Input #5
7
N/O Input #8
2
C Input #5
8
C Input #8
3
N/O Input #6
9
Not Used
4
C Input #6
10
Not Used
5
N/O Input #7
6
C Input #7
Dimensions (with mounting plate) 6.3” L x 4.8” W x 4.3” H
DIGITAL ADDRESS & FREQUENCY SET-UP
This transmitter is factory programmed to Frequency #1 and Digital
Address “0”. These settings can be changed by the user in any
combination
but must match the corresponding receiver(s).
1)
Remove top cover.
2)
Select desired address and/or network frequency
3)
Move SW4 on SEL2 to the “CLOSED” position. The TX LED will
illuminate RED (no data is being transmitted during this
programming)
4)
Once LED is illuminated, move SW4 on SEL2 back to the
“OPEN” position. The TX LED will illuminate GREEN.
5)
Programming is now complete. Replace top cover.
Note – Selected address and frequency settings will be maintained, in
the internal flash memory, even if power is removed from unit. The
above procedure needs to be performed only if
changing
digital
address and/or network frequency)
SEL1
(ADDRESS)
Seven dip switches for selecting digital address of this
transmitter (Maximum of 128 combinations)
Network
Address
SW1
SW2
SW3
1
OPEN
OPEN
OPEN
2
CLOSED
OPEN
OPEN
3
OPEN
CLOSED
OPEN
4
CLOSED
CLOSED
OPEN
5
OPEN
OPEN
CLOSED
6
CLOSED
OPEN
CLOSED
7
OPEN
CLOSED
CLOSED
SEL 2 (SW 1-3):
(NETWORK
FREQUENCY)
8
CLOSED
CLOSED
CLOSED
Normal Operation
Programming
SEL2 (SW4)
OPEN
CLOSED
