EN D 031 Rev D
Page 12 of 17
Assembly
Note: All assembly should be performed in a dry, dirt free area.
1.
Install the left hand crank shaft into the spider body. When inserting the shaft, put the
spacer and lift arm back in their correct positions.
2.
Repeat for the right hand crank shaft.
3.
Install the link onto the left and right hand crank shafts. Hold the link arm onto the shafts
by the two retaining rings.
4.
Move the link to the left. Rotate and shift the lift arm on the crank shaft until the holes
for the taper pins are aligned. Drive the taper pins back through the lift arm and crank
shaft. Install the set screw and tighten to hold these two parts in relation to each other.
5.
Repeat the above for the right hand crank shaft.
6.
Align the cylinder yoke with the hole in the link. Insert the bolt and tighten the nut until
the nut edge is flush with the end of the bolt.
7.
Install the slip assemblies back onto the lifting arms.
8.
Function test the spider to verify proper operation.
Storage & Transportation
1.
Unpainted surfaces should be coated with rust preventing agent.
2.
Prevent excessive exposure to water and moisture.
3.
Clean the tool after use – steam clean as needed; remove mud, debris and any other
substances.
4.
Ensure the pneumatic/hydraulic connections are clean and install dust caps.
5.
Transport the unit on a suitable container or pallet.
