AERONKISH
Made in the USA by
Buzzard Models LLC
Please read and understand all steps to these instructions before beginning assembly. This plane is not a toy and
is very dangerous to operate. Children should not operate this aircraft without adult supervision.
Before you start, it may be a good idea to gather the required items to complete this plane. You will need some
glue, elmers school glue and some 5 minute epoxy will work. You will also need a micro receiver minimum 3
channels, a 2s 7.4 volt 300mah 20c lipo battey, a battery charger, and a 3 channel transmitter.
Fuselage parts
Locate fuselage sides, cabin top and two
5-1/8” bamboo rods
With cabin top temporarily in place, glue
bamboo rod to fuselage side alining
bottom with bottom of doubler.
Repeat on other side.
Glue front and rear fuselage bottom. Find
F1, F2, and F3. glue into place. Make
sure slot in F1 faces forward.
Locate cabin floor and cabin top, glue
into place.
Locate landing gear leg and press into
slot.
With one fus. Side temporarily in place,
glue gear plate on with foam safe CA ,
epoxy, or white glue.
Using white school glue, glue both
fuselage sides, front fuselage top and
firewall into place. Start at front.
