18
3. Open controller which is connected to the gas cylinder tap.
4. Press the safety device control button (C) for about twenty seconds and keep it pressed while
repeatedly pressing the button of the piezo ignitor (A).
5. Check the flame indicator (B) to see whether the flame is alight. When the red line is in the green
zone, the refrigerator is on.
6. Hold the safety device control (C) for 10-15 seconds.
7. Release the safety device control (C) and check that the flame is alight again.
8. Position of the thermostat knob (D) to position 4 (max.) during the first 6 hours with the empty
refrigerator. After these 6 hours, locate the thermostat knob in mid-position (depending on the
temperature you want). Can already put food into the refrigerator.
To switch off the refrigerator, close the valve of the gas bottle regulator.
TEMPERATURE REGULATION
(see Figure 1)
It will take several hours for the refrigerator to reach normal operating temperature.
The main compartment of the refrigerator temperature is controlled by a thermostat. The thermostat
knob (D) should be fixed at 1-4. If you want a lower temperature (colder), set the thermostat to a
higher figure.
TURN THE REFRIGERATOR OFF
If the refrigerator is not going to be used for a while:
1 Close the valve of the gas regulator.
2. Empty the refrigerator. Defrost and clean as described in the following paragraph. It must be
completely dry inside to prevent mold growth (if possible, leave the door open).
3. Adjust the thermostat control to the minimum position (D).
CHANGING THE DIRECTION OF THE DOOR (OPTIONAL)
How to reverse the door:
·
Remove the lower hinge by loosening and removing the screws with a screwdriver (2).
·
Gently lower the door and pull it.
·
Remove the three screws of the hinge (1) upper left position, remove the plastic part of the
hinge position.
·
Remove the three screws from the top hinge right and detach hinge, insert the plastic part,
rivet thereafter three screws.
·
Remove the lower hinge and attach to the opposite side.
·
Take the door. Insert the shaft of the bottom hinge into the hole on the bottom right of the
door.
·
Secure the hinge to the top left position of the Cabinet. Adjust the door, that is straight and
in alignment with the Cabinet.
Note: Due to transport, it may be the gasket (rubber door) and hold. After giving the back door,
weatherstrip has to catch the right way, to favor to seal and prevent air loss. If there is a space
MINIMUM
MAXIMUM
MEDIUM
