GB
Page 14 of 62
INSTRUCTION, USE AND
MAINTENANCE MANUAL
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
1297-M021-1_B
9.3
Assembly procedures
9.3.1 Fitting the mandrel on the flange
Only for LIBRAK380.3DTEC - LIBRAK430.3DTEC
models
Screw the mandrel with an Allen wrench (
Fig. 7 ref. 1
)
on the flange (
Fig. 7 ref. 2
).
1
2
Fig. 7
9.3.2 Fitting and removal of the pneumatic
mandrel on the flange
Only for LIBRAK380P.3DTEC -
LIBRAK430P.3DTEC models
FITTING
1. After making power and air connections switch on
the machine (the pneumatic mandrel always opens
when the machine is switched on). Switch the ma-
chine off. Fit the internal mandrel on the flange
and tighten it with the wrench provided (
Fig. 8
and
Fig. 9
).
Fig. 8
Fig. 9
