INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 19 of 52
15.0 WHEEL BALANCING
15.1 Determination of wheel dimensions
15.1.1 Manual setting of wheel dimensions
The wheel balancers feature a graduated scale for the
manual detection of the distance for weight fitting.
The value of machine's distance from rim is always set
with “mm” measurement unit.
Rim width and diameter values, on the other hand,
can be set in “inches” or “mm”; in the examples in this
manual “inch” introduction is indicated.
The rim diameter and width have to be measured
directly on the rim itself or detected by means of the
manual caliper (on issue) only for the rim width (see
Fig. 18
).
In order to insert such values or to check them again
the operator will have to carry out the following pro
-
cedures:
- from wheel dimensions page, press key
to
select the value to be edited or set; the digit on the
display corresponding to the value to be edited is
flashing.
- Press the
/
keys until the desired
value is reached.
- Press the
key to confirm and to move to the
next value to be edited or set.
The graduated scale shall be positioned inside the rim,
at the distance where any adhesive weight shall be fitted
(for example
ALU-S
), or sometimes against rim inner
edge (for example
DYN
). To make user’s job easier, the
corresponding LED will flash on rim shape displaying.
Fig. 16
Both LEDs
will flash
ALU-S
program
DYN program
LED inside
the rim flashing
ALU2 program
Both LEDs
will flash
Fixed LED
1294-M015-0_B
LIBRAK240RTLD - LIBRAK240RTLCD
