Butler HP441S.18, Инструкция по эксплуатации

Страница: 12 / 72

INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 12 of 36
GB
10.5 Electrical connections
EVEN THE TINIEST PROCEDURE
OF AN ELECTRICAL NATURE
MUST BE CARRIED OUT BY PRO-
FESSIONALLY QUALIFIED STAFF.
BEFORE CONNECTING THE MA-
CHINE MAKE SURE THAT:
• THE MAIN POWER RATING COR-
RESPONDS TO THE MACHINE
RATING AS SHOWN ON THE
MACHINE PLATE;
• ALL MAIN POWER COMPO-
NENTS ARE IN GOOD CONDI-
TION;
• THE ELECTRICAL SYSTEM
IS PROPERLY GROUNDED
(GROUND WIRE MUST BE THE
SAME CROSS-SECTION AREA
AS THE LARGEST POWER SUP-
PLY CABLES OR GREATER);
• MAKE SURE THAT THE ELEC-
TRICAL SYSTEM FEATURES A
CUTOUT WITH DIFFERENTIAL
PROTECTION SET AT 30 MA.
As envisaged by the regulations in force, the machine is
not equipped with a master circuit breaker, but simply
has a plug-socket connection to the electrical mains.
The machine is supplied with free cable of mt. 3 . A plug
corresponding to the following requirements must be
connected to the cable:
• Conformity to Norm
IEC 309
• 230/400 Volt – 16A
•
3P + Ground
• IP 44
2. Connect the flexible pipes ( Fig. 9 ref. 1 ) preas-
sembled on the mandrel rotary distributor ( Fig. 9
ref. 2 ) on the valve ( Fig. 9 ref. 3 ) hosenipple
( Fig. 9 ref. 4 ). Fasten the pipes ( Fig. 9 ref. 1 ) with
the prepared clamps ( Fig. 9 ref. 5 ).
3. Connect pipe (
Fig. 9 ref. 14
) from the greaser re-
duction gear filter (
Fig. 9 ref. 7
) (air not lubricated)
to the pedalboard (
Fig. 9 ref. 12
).
4. Connect the pipe ( Fig. 9 ref. 11 ) from the pedal-
board lower valve ( Fig. 9 ref. 12 ) to the blow valve
( Fig. 9 ref. 13 ) union ( Fig. 9 ref. 4 ).
5. Connect the pipe ( Fig. 9 ref. 6 ) to the T coupling
( Fig. 9 ref. 8 ) and the coupling ( Fig. 9 ref. 16 )
placed on the tank ( Fig. 9 ref. 9 ).
6. Connect the pipe ( Fig. 9 ref. 10 ) from the valve
( Fig. 9 ref. 15 ) to the pedalboard ( Fig. 9 ref. 12 ).
7. Connect the pipe ( Fig. 9 ref. 17 ) from the valve
( Fig. 9 ref. 15 ) to the inflation unit ( Fig. 9 ref. 18 ).
Fig. 9
IN CASE OF A CHANCE SUP-
PLY FAILURE, AND/OR BEFORE
ANY PNEUMATIC CONNECTIONS,
MOVE THE CONTROLS TO THE
NEUTRAL POSITION.
7300-M023-0_B
HP441S.XX - HP441S.XXFI
HP441SQ.XX - HP441SQ.XXFI