TLX4x4 Bushman Fridge Box, Installation Manual
TLX4x4 Bushman Fridge Box, Installation Manual
90-20-0006_A-1
TLX4x4
BUSHMAN FRIDGE BOX
Installation Steps
To be read in conjunction with Bushman Fridge Owners Manual
1.
Before commencing assembly, use Item 6 (Bottom Panel) as a template to drill
holes in the desired installation location for the Fridge Box.
2.
Lay Item 6 (Bottom Panel) on floor and place the fridge in position.
3.
Take Item 7 (LHS Panel) and loosely fasten it to the bottom panel using 3 x
Item 1 (Screws).
4.
Loosely fasten Item 9 (Plastic Strip) through holes in Item 7 (LHS Panel) and
into the fridge by using 4 x Item 2 (Self Drilling Screws).
Note: there are pre-drilled holes in the front edge of the fridge.
Loosely fasten Item 10 (Plastic Strip) through holes in rear edge of Item 7 (LHS
Panel) and into the fridge by using 2 x Item 2 (Self Drilling Screws).
5.
Repeat Steps 3 and 4 for Item 8 (RHS Panel).
6.
Loosely fasten Item 4 (Rear Panel) to Item 7 (LHS Panel) and Item 8 (RHS
Panel) using 3 x Item 1 (Screws) on each side.
7.
Insert Item 3 (Bush Snap) into one of the 4 holes that is best located to suit
the electrical wiring for power, and feed the power cord through.
8.
Loosely fasten Item 5 (Top Panel) to Item 7 (LHS Panel), Item 8 (RHS Panel)
and Item 4 (Rear Panel) using 3 x Item 1 (Screws) on each side and 2 x Item 1
(Screws) on the rear.
9.
Check and tighten all Fridge Box screws.
10.
Place the assembled Fridge Box in the desired position and fasten it using
appropriate nuts, bolts and washers (not provided).
CAUTION: DUE TO LASER CUT PANELS, BE MINDFUL OF SHARP EDGES WHILE ASSEMBLING.
tlx4x4.com.au
bushman.com.au
TLX4X4
BUSHMAN FRIDGE BOX
Installation Manual
