Page 7
Storing a station preset
1:
To store a tuned station to a preset location press
the
MEMORY
button
(27)
‘CH01’
will appear on the
display to indicate Preset location
‘01’
.
2:
Press the
/
buttons
(23/21)
on the remote or
press and hold
(4/5)
on the unit to cycle through the
preset locations
1
-
20
.
3:
When the preset location required is selected press
the
MEMORY
button
(27)
again to store the tuned
station .
Recalling a station preset
1:
To select a preset in radio mode either press the
required numeric button
(s)
or use the
/
buttons
(23/21)
on the remote or press and hold
(4/5)
on the unit to cycle through the preset locations .
Bluetooth operation
When using the Bluetooth connection, you can listen to
audio wirelessly from a Bluetooth stereo audio device
within 10 metres of the CMC4BTMP3.
1:
Select
BT
mode using the instructions from the
‘Switching modes’
section .
2:
When the Bluetooth mode is selected a
BLUE
indicator led will flash
3
times and then a beep will
be heard . The unit is now in pairing mode and will
pair with any previously connected devices . When
in pairing mode a
RED
indicator led will flash until
paired .
3:
If you have not connected a device you can now
enable
‘discovery’
mode on your device and select the
CMC4BTMP3
Bluetooth connection . If you are asked
for a pass code enter
‘0000’
.
NOTE: If you turn off either device before pairing
is complete the process will need to be repeated
when powered ON again.
4:
Once paired the
BLUE
led indicator will flash slowly
and a beep will be heard .
5:
When playback from the device is initiated the
RED
&
BLUE
led indicators will flash simultaneously
6:
If using a mobile phone as an audio source, when
receiving a call audio playback stops while you receive
the call . When you hang up the audio is restored .
7:
To disconnect
(un-pair)
a connected bluetooth device
press the
PAIR
button
(38)
.
Bluetooth operation (cont)
When making a phone call you will need to either
disable bluetooth on your mobile device or switch to
another source input should you not wish the call to
be output from the speakers.
NOTE: the volume output is effected by the
volume level on the audio source EG: Phone or
laptop, so make sure that is set to about 70-80%
(not too loud to avoid distortion).
Any obstacles between devices may affect the
bluetooth connection
When a mobile phone is paired with too many
devices, you may need to clear the pairing history
to connect.
Connecting an external audio device
External audio sources such as iPod’s & MP3 players
can be connected using a 3.5mm to RCA audio cable
(not supplied).
110-240V~ 50/60Hz
20W
1:
Connect the
3
.
5
mm end of the cable to the
AUDIO
devices headphone /Line output and
RED
&
WHITE
RCA
plugs to the
LINE IN
input
(14)
on the rear of the
unit .
NOTE: Make sure the RED plug connected to the
RED input and the WHITE plug to the WHITE input.
2:
Select
LINE IN
mode using the instructions from the
‘Switching modes’
section .
3:
Press play on the external audio device .
4:
Adjust the volume to your desired level .
User instructions