Bush Hog MS1300P, Руководство оператора

Страница: 28 / 44

Service and Maintenance
MS1300P
Manure Spreader
28
9. Service and Maintenance
WARNING!
Risk of serious personal injury. Stop engine
before performing ANY service or maintenance
procedure. Reinstall all covers and shields
removed before putting machine back into
service.
W033
9.1 Maintenance Safety
• Good maintenance is your responsibility. Poor maintenance
is an invitation to trouble.
• Read and understand all the information in the Safety
section that starts on
page 8.
• Follow good shop practices that include, but are not limited
to the following:
-
Keep the service area clean and dry.
-
Ground electrical outlets and tools correctly.
-
Make sure that there is an adequate amount of light for
the current task.
• Never operate the tractor in a closed building. The exhaust
fumes may cause asphyxiation.
• Never work underneath equipment unless it is securely
supported by blocks.
• Always wear the appropriate PPE.
• When replacement parts are required, only use genuine
original equipment manufacturer (OEM) parts. Bush Hog
cannot be held responsible for damage or injuries that are
caused by use of unapproved parts or accessories.
• Inspect and tighten all bolts, nuts, and screws.
• Reinstall all safety shields and covers after completing
service or maintenance.
• Use regular cleaners to clean parts. Do not use gasoline.
• Always use the correct tools for the task, make sure that
the tools are in good condition, and understand how to use
them.
• Have a qualified tire dealer or repair service complete all
required tire maintenance. Do not attempt to mount a tire
unless you have the proper equipment and experience for
this task. Failure to follow the correct procedures when
mounting a tire on a wheel or rim can cause an explosion,
which may result in serious injury or death.
• When replacing worn tires, make sure that they meet the
original tire specifications. Never undersize a tire.
9.2 Grease Type
Use an SAE multi-purpose high temperature grease with extreme
pressure (EP) performance. Alternatively, an SAE multipurpose
lithium-based grease is acceptable.
9.3 Maintenance Schedule
Complete maintenance procedures at the specified time or hour
interval, whichever comes first.
After Each Use
Clean the manure spreader. For instructions, see Before
Storing the Manure Spreader on page 27.
Every 8 hours or Daily
Grease the PTO shaft. See page 29
Check the tire pressure. The specified tire
pressure is located on tire sidewall. Inflate, as
required
Check the wheel lug-nut torque. See page 39
Check the tightness of all fasteners. See page 37
Check the hinge and pivot point lubrication.
Lubricate, as
required
Check the apron-chain lubrication. See page 31
Check the drive-chain lubrication and
tension, and the sprocket condition.
See page 31
Check the speed-control rope operation
and condition. Replace, as
required
Complete the pre-operation checks. See page 23
Every 50 hours or Annually
Check the gearbox oil level. If required,
change the oil.
See page 33
Check / adjust the PTO drive belt tension
and condition.
See page 34