BUSCH COBRA NC 1000 B, Инструкция по эксплуатации

Страница: 6 / 32

2 | Product Description
6 / 32 Instruction Manual COBRA NC 1000 B WCV_EN_en
NOTE
Illustrations
In this instruction manual the illustrations may differ from the machine appearance.
2.1 Operating Principle
The machine works on the one-stage, twin-screw pump principle.
Two screw rotors are rotating inside the cylinder. The pumped medium is trapped be-
tween the cylinder and screw chambers, compressed, and transported to the gas out-
let. During the compression process, the two screw rotors do not come into contact
with each other nor with the cylinder. There is no need for a lubrication or an operating
fluid in the compression chamber.
2.2 Application
The machine is intended for the suction of air and other dry, non-aggressive, non-toxic
and non-explosive gases.
Conveying of other media leads to an increased thermal and/or mechanical load on
the machine and is permissible only after a consultation with Busch.
The machine is intended for the placement in a non-potentially explosive environment.
The machine is capable of maintaining ultimate pressure, see Technical Data [ ► 29] .
The machine is suitable for continuous operation.
Permitted environmental conditions, see Technical Data [ ► 29] .
2.3 Start Controls
The machine comes without start controls. The control of the machine is to be provid-
ed in the course of installation.
The machine can be equipped with a soft-starter or a variable-frequency drive.
2.4 Standard Features
2.4.1 Water Cooling
The machine is cooled by a cooling liquid circuit in the cylinder cover and cylinder.
The cooling liquid pump (CLP) allows a recirculating flow in the cooling liquid cham-
ber.