Burster DIGIFORCE 9311, Руководство по эксплуатации, Страница: 194 / 216

194
of 216
7.8 M7 Order sheet
The "M7 Order sheet" measurement menu is not used for displaying specific measurement data or
results. It is a "data container" via which you can transfer administrative or component-specific
information for data-logging purposes. You can edit the order sheet manually in the "Order sheet" menu
(M52) (for details, please see section 6.1.12 "Order sheet" on page 57). It is far more efficient, however,
to perform reading/writing via the Fieldbus interface to a PLC (e.g. via PROFIBUS). In this case, the PLC
can write relevant information to the container, and this information can then be saved by logging the
measurement data after the measurement (e.g. using the DigiControl PC software).
The order sheet is created globally and not for a specific program, i.e. the same set of data is used
whatever the measurement program.
Parameters in the "Order sheet" menu (M52)
Parameter Meaning
Operator Name of operator (string [64 characters])
Order number A123456B (string [64 characters])
Batch Z987654321A (string [64 characters])
Component Component name (string [64 characters])
SN1 Serial number SN1 (string [64 characters])
SN2 Serial number SN2 (string [64 characters])
Diagram 88: M7 Order sheet
The DigiControl PC software logs
measurement data and additional
information
The PLC transfers data to the
DIGIFORCE
®
9311 (e.g. operator,
component, order no.)