Burster 9163, Руководство пользователя, Страница: 57 / 162

Digital indicator Model 9163
Page 57
5. Power-up
Optimum performance of the instrument depends on configuring and setting the control parameters
correctly.
The versatility and high performance of these instruments is achieved by setting a large number of
parameters. These can either be preset directly using the buttons on the control panel, or by downloading
a configuration file using the DigiVision software, for which you need the optional RS232 interface.
The DigiVision software only lets you configure the digital indicator. To capture sensor readings you need
to purchase the 9163-P100 software.
5.1 Self-diagnosis
PV
Figure 7: Self-test
The instrument performs a self-test immediately after power-up. During this test, all segments of the
display and the 7 LEDs flash.
If the instrument passes the self-test successfully, it switches to normal operating mode
(Main menu / level 1).
If the self-test identifies a fault, an error code is displayed. This error code is also saved in the
parameter
ERR
in the menu
INF
.
The error codes and their meanings are listed in section: 5.3 "Errors during measurement mode" on
page 58.
5.2 Measurement mode
PV
Figure 8: PV, displays the actual value.
You can cycle through each of the channels and the alarm limits by pressing the [F] button briefly to
display their values on the PV display. These are used to define the operation of the instrument in the
main menu.
You can use the ▲ und ▼ buttons to increment or decrement the selected limit to the required value.
Holding down the [F] button for 3 seconds returns you to the main menu.
You can switch between net and gross values using the keyboard or the digital inputs. When the gross
value is being displayed, the decimal point flashes beside the units digit.
You can find further information on operating the unit in section 6: "Basic operation" on page 59.