14
Headphones output
The 099 offers two outputs for headphones. A
Headphones Preamplifier output (14)
and
a conventional
Headphones socket (15)
for 6,3mm stereo jacks.
The
Headphones Preamplifier output (14)
is designated for headphone amplifiers or
wireless headphones. These outputs always receive the output signal, regardless whether
headphones have been connected to the
Headphones socket (15)
or not.
The
Headphones socket (15)
accepts headphones with a 6,3mm stereo jack and
impedance greater than 16
Ω.
CAUTION:
To avoid any damage the playback via the two preamplifier outputs
RCA
(24)
and
XLR
(23), (25)
is cut off automatically when a headphones jack is plugged in. For safety
reasons the volume is adjusted to its lowest level when plugging the jack in or pulling it out
of its socket. The playback volume of the headphones can be adjusted with the
Volume
control knob (7)
on the front panel or with the
and
VOLUME –
buttons on the
remote.
However, you do have the possibility to listen to music via the preamplifier outputs
RCA (24)
and
XLR (23), (25)
without having to unplug your headphones. By briefly pressing the
OSD
button on the remote you can switch between the
Headphones jack (15)
and the two
preamplifier outputs
RCA (24)
and
XLR (23), (25)
. For safety reasons the volume is
adjusted down to the lowest level at each switch. The
Headphones Preamplifier output
(14)
is not affected by these changes. It is always on.
REMOTE
By connecting the
DC OUT (21)
socket with a corresponding DC IN socket of another
Burmester component you enable the 099 to remotely switch this other component on or off.
In this operating mode the 099 functions as master.
By connecting the
DC IN (22)
socket with the corresponding DC OUT socket of another
Burmester component the preamplifier can be remotely switched on or off by this other
component. In this case the 099 preamp functions as slave.
BURLINK
The ports for
BUR
mester-
Link
interfaces
(12), (13)
will accept all kinds of control systems
(for example PC, CRESTRON
, AMX
etc.). These systems offer a convenient way to
control your complete playback system, for example using a programmable touch panel.
The LEDs next to these ports marked
T
and
R
(for
T
ransmit and
R
eceive) indicate data
exchange activity.
The commands for controlling the 099 preamp can be found in the chapter
BURLINK
.
Содержание 099
Страница 1: ...OWNER S MANUAL CLASSIC LINE 099 PREAMPLIFIER HIGH END MADE IN GERMANY ...
Страница 2: ...VERSION 1 2 from August 15th 2018 ...
Страница 27: ...23 REMARKS ...
