burmeier Vertica-Homecare, Инструкция по эксплуатации

Страница: 36 / 84

Instruction Manual for Vertica-Homecare Bed
Page 37
 The footboard [20] with the label must be inserted pointing to the
outside of the bed.
 Bring the mobilisation supports into the slightly inclined position “1”. (If the
footboard is already inserted, only simultaneously;
without inserted footboard, it's possible to do this
sequentially); Chapter 4.3.5.1
 Using both hands, slide both release sliders [1] on the
footboard [20] towards the inside simultaneously and
 cautiously fold the footboard inwards towards the
middle of the bed
The surface of the footboard provides the patient with a
horizontal table top, for example, for eating, writing, or
supporting a book.
4.3.9 Ending the Stand-Up Function
Requirement
The mattress base must be moved back until the thigh rest and lower leg rest are
flat and horizontal by using the NURSE handset and holding down the button .
The backrest remains slightly inclined.
The stand-up function is only ended when:
 The NURSE handset has not been operated for two minutes,
or
 Previously the button shown on the NURSE handset [15] was held
down for at least 3 seconds.
When ending the stand-up function:
 The orange flashing light on the NURSE handset [15] extinguishes:
The handset is locked
 The normal patient handset [3] is active again.
 All normal functions of the electrical actuator system can be used
again; see Chapter
4.2 .
20
1