Burkert Flowave 8098, Руководство по эксплуатации

Страница: 308 / 354

308
Menu Parameter
Type 8098 FLOWave L
21.2.5 Changing the address of the default gateway
Before commissioning the device, you must change the address of the gateway.
Do the following:
→
Go to the
CONFIGURATION
view.
→
Industrial communication
→
Confirm to access the Parameter view.
→
IP settings
→
Default gateway The current gateway address is displayed.
→
Set the new address of the gateway.
→
Save.
The address of the gateway is changed.
21.2.6 Reading out the IP address assigned by a DHCP
When the device is connected to a network that uses DHCP mode, a temporary IP address is automatically
assigned to the device. You can read out this address.
Do the following:
→
Go to the CONFIGURATION view.
→
Industrial communication
→
Confirm to access the
Parameter
view.
→
IP settings Temp. IP address
→
Go back to the parent menu.
If the device is removed from the network and again connected to this network, another temporary IP
address is assigned to the device.
21.2.7 Choosing the internal cycle time
The internal cycle time is the refresh time of the data in the industrial communication module.
Do the following:
→
Go to the CONFIGURATION view.
→
Industrial communication
→
Confirm to access the Parameter view.
→
Advanced settings
English