Burkert Flowave 8098, Руководство по эксплуатации

Страница: 291 / 354

291
Outputs – Parameter
Type 8098 FLOWave L
To change the damping level of the values transmitted on an analogue output, do the following:
→
Go to the CONFIGURATION view.
→
Outputs
→
Confirm to access the Parameter view.
→
Output 1: analog or Output 3: analog
→
Damping
→
Choose the damping level.
→
Save.
The damping level is changed.
18.3.3 Configuring the behaviour of an analogue output depending on
the status of the device
Depending on the status of the device, the analogue output:
• can continue to transmit the process values.
• or, can transmit and hold the last process value. The choice is not available if measurements are
impossible.
• or, can transmit a 22 mA current. The choice is not available if measurements are impossible.
• or, can transmit a 3.6 mA current. The choice is not available if measurements are impossible.
• or, can transmit any preset current value (i.e. a
Forced value
).
To change the behaviour of an analogue output depending on the status of the device, do the following:
→
Go to the
CONFIGURATION
view.
→
Outputs
→
Confirm to access the Parameter view.
→
Output 1: analog or Output 3: analog
→
Behaviour
→
Choose Impossible to measure or Failure or Out of spec. or Maintenance req.
The current behaviour is displayed
→
Choose the behaviour associated to the device status.
→
If the behaviour is set to Forced value , then set the current value to any value in the range
3.5...23 mA.
→
Save.
The behaviour of an analogue output is changed.
English