Burkert Flowave 8098, Руководство по эксплуатации

Страница: 169 / 354

169
SAW sensor – Parameter
Type 8098 FLOWave L
15.5.7 Changing the error limits, the warning limits and the hysteresis
of the mass flow rate
To change the error limits, the warning limits and the hysteresis of the mass flow rate, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Mass flow
→
Limits
→
Settings The Current settings are displayed
→
Set the high error limit
→
Set the low error limit
→
Set the high warning limit
→
Set the low warning limit
→
Set the hysteresis value The New settings are displayed.
→
Save.
The limit values and the hysteresis value are changed.
15.5.8 Resetting the default values of the error limits, the warning
limits and the hysteresis of the mass flow rate
The default values of the error limits, the warning limits and the hysteresis of the mass flow rate depend on
the DN of the measurement tube:
•
high error value: maximum mass flow rate value authorized for the DN,
• low error value: opposite value of the high error value,
• high warning value: 80 % of the maximum mass flow rate value authorized for the DN,
• low warning value: opposite value of the high warning value,
• value of the hysteresis: 0.0 l/min.
To reset the default values of the error limits, the warning limits and the hysteresis of the mass flow rate, do
the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
English