Burkert 8745 MFC Ethernet, Руководство по эксплуатации

Страница: 65 / 70

65
Accessories, Spare Parts
Type 8745 Ethernet, 8745 Analogue
12.3.12 Set-point value is not reached (MFC)
Identify the cause to solve the problem:
1. The mesh filter is clogged.
→ Clean or replace the mesh filter.
→
Run the Autotune function to adapt to the operating
conditions.
2. The inlet pressure is too low.
→
Increase the inlet pressure to the calibration pressure value.
3. The outlet pressure is too high.
→
If the fluid connection pipes after the product are dirty, then
clean them.
13 AccEssOriEs, spArE pArTs
CAUTION
risk of injury and risk of material damage that are due to
unsuitable parts.
Incorrect accessories and unsuitable replacement parts can
cause injuries and damage to the product and its environment.
▶
Only use original accessories and original spare parts from
Bürkert.
13.1 Electrical accessories
Tab. 36: Electrical accessories, product variant Analogue with D-sub
DE-9 male connector
item article number
D-sub DE-9 female connector with 5 m
cable, with stripped end
580 882
D-sub DE-9 female connector with 10 m
cable, with stripped end
580 883
Tab. 37: Electrical accessories, all product variants
item article number
büS stick set (without power supply) 772551
Memory card On request
→ For further accessories, refer to the product datasheet.
English