STM-4D Installation and Operation Manual Rev B
3
TEMP
–
OUTDOOR Sensor
The TEMP-OUTDOOR digital outdoor temperature sensor is included with
the STM-4D, and is intended for general purpose monitoring of equipment
or ambient temperatures.
The TEMP-OUTDOOR sensor is attached to
25’ of cable
with an RJ-12
connector on the end. The sensor has a mounting ring and gasket to
accommodate #6 or #8 hardware. The sensing elements are sealed for added protection from dirt and
moisture.
TEMP
–
INDOOR Sensor
The TEMP-INDOOR Sensor is a general-purpose, digital, indoor temperature sensor
tailored for monitoring ambient temperatures within a room or in an equipment
rack. Cables are not supplied with this sensor
—
o
rder Burk’s 25’ 6
-conductor cable
with RJ-12 connectors on both ends (part number SENSOR CABLE) or supply your
own.
TEMP
–
WALLMOUNT Sensor
The TEMP-WALLMOUNT Sensor
is housed in a 2 5/8” x 5” enclosure with air vents to
facilitate sensing of the environment.
14
’ of cable
is provided with an RJ-12 connector on one end. The TEMP-INDOOR has a
large, easy to connect barrier strip that accommodates flat or Phillips type
screwdrivers.
TEMP
–
STACK Sensor
The TEMP-STACK Sensor is a digital stack temperature sensor
designed for sensing heat within the air ducting of your equipment.
The TEMP-STACK Sensor is attached
to 25’ of cable
with an RJ-12
connector.
The sensor is mounted in the tip of a 3/8” diameter chrome tube. The supplied mounting hardware
consists of a base and a compression fitting to allow the sensor to be secured at variable depths. This
allows the installer to locate the sensor up to 9 1/2
” from the equipment wall, well within the airflow
being monitored.