9
Powder Hopper Setup
1. Remove the powder hoppers from the
packaging. Before filling each with the
appropriate product, verify that the auger
spring is in it's correct position. If the auger
spring is not engaged, rotate the auger
driveshaft clockwise till the auger spring is
fully seated as shown.
2. Before installing the powder hoppers, take note,
that at the rear of each hopper is a cavity that
corresponds with a locating block in each of the
powder hopper locations. When a hopper is
placed in position, the locating block fits into
the cavity, thus ensuring proper powder hopper
placement. Also, the front of the hopper needs
to be placed behind the retaining tab directly
behind the whipper mixing bowl.
3. Fill the hoppers, then install one on either side of
the machine as shown.
INITIAL SETUP
1
2
3
continued >
