manual-rmp210-rmp3545-en-18
Page
7 / 16
If the machine is heated higher than 175 ° C, a cooling fan (on the back of the machine) must be
manually switched on to cool the periphery.
Pay attention to suitable materials to avoid fire and related financial losses.
Continue to ensure suitable pressing temperatures to prevent burning of the printed circuit board
material and thus the possible formation of toxic and hazardous gases.
Allow the machine to cool down to a maximum of 50 ° C (approx. 30 - 45min) to avoid severe skin
burns when removing it, or wear suitable gloves.
At temperatures above 200 ° C, purely optical colour changes of the press plates may occur.
These do not represent any technical defects.
Exhaust
Extracting the room air in the area above the machine body is recommended with regards to
possible PCB gas emissions. The need for extraction depends on the materials used and the
temperatures set.
Pressure
Before the compressor starts after switching on the machine, remove all parts from the press
plates, which could damage the machine or cause it to burst and can be propelled out of the
machine.
Machine must not be operated without the two 10 mm press plates!
Compressor
WHILE THE COMPRESSOR IS RUNNING, DO NOT OPEN THE MACHINE OR OPEN THE
DOOR TO THE PRESS ROOM.
Composition
Presskammer
Press compartment
Bedieneinheit
Operating panel
vorne Lagerraum
hinten Kompressor
front storage
back compressor
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
