Bulls 22-15-1054, Руководство пользователя, Страница: 207 / 321

MY22B01 - 22_1.0_27.08.2021
206
Maintenance
8.5.8.5 eightpins H01 seat post
Only applies to pedelecs with this equipment
Removing the seat post
1 Use a 5 mm hex spanner to unscrew the
Postpin axle.
Figure 233: Undoing the seat post

Detach Bowden cable from the on-bar remote
control on the seat post.

Detach the operating lever from the handlebars
in the case of under-bar-remote control on the
seat post. Activate operating lever. Hold
Bowden cable fastener and pull or tilt forwards.
.
Figure 234: Unfastening the remote control
2 Pull seat post slowly out of the frame.
Figure 235: Removing the seat post
3 Pull out the special end cap for the outer sleeve
from the bracket.
4 Detach the Bowden cable head from the
hydraulic activation lever bracket.
5 If necessary, operate the lever by hand to
make more space for detaching it.
Figure 236: Removing the Bowden cable
Removing the outer sleeve and slide bushing
1 Use a 3 mm hex spanner to remove
attachment screw on the outer sleeve.
2 Detach outer sleeve by pulling upwards with
your hand.
3 Pull slide bushing tube out of the seat tube.
Figure 237: Removing the outer sleeve and slide bushing
Caring for the outer sleeve
1 Push the blue wiper towards the edge.
2 Detach the seal lip ring.
Figure 238: Detaching the seal lip ring
3 Detach spring washer or outer sealing ring.
Figure 239: Removed spring washer