CAB15RAUPGRADE
Instructions
www.bullard.com
CAB15RAUPGRADE includes:
• LED Lights:
1 Yellow
2 Green
1 Red
• Wiring harness with remote alarm connection
• Labels:
1 Power
1 CO
• Mounting Screws for Remote Alarm Connection
• Hole Placement Templates (located on page 3 of this manual)
Template for remote alarm connection
Template for Power and CO lights
Installation Instructions
Drilling of Hole for Remote Alarm Connection
Place template #1 on the side of the box above the power cord connection.
Trace the template. Using a 7/8” drill bit, drill the large hole for mounting the
remote alarm connector (Figure 1). Using a 5/32” drill bit, drill the smaller
screw holes(Figure 1).
NOTE:
See Figure 2 for completed installation of Remote Alarm Connection
Drilling of holes for installation of the CO and
Power Lights
The holes for the CO and Power lights will be located on the top of the case,
adjacent to the latches (Figure 3). Use Templates #2 and #3.
Using the templates, mark the top of the box and drill the 2 light holes on
either side of the box using a 9/16” drill bit. The light holes will be drilled
toward the inside of the area leaving room for the labels to be applied
(Figure 3).
Installation of the Power (AC/DC) indicator
lights.
Using 1 Green light and 1 Amber light, remove the lock washer and split
ring. Leave the gasket on the light. Insert the green LED light in the top hole
(Figure 4) and then put the lock washer on and follow with threading the nut
on to secure the light into the box. Repeat with the Amber light in the bottom
hole (Figure 4).
Installation of the CO Indicator lights
Using 1 Red and 1 Green light, remove the lock washer and split ring. Leave
the gasket on the light. Insert the Green light in the top hole (Figure 4) and
then put the lock washer on and follow with threading the nut on to secure
the light into the box.
Repeat with the Red light in the bottom hole (Figure 4).
Apply the labels on either side of the lights (Figures 5 and 6).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
