Bull ESCALA Power7 5886, Руководство по установке, Страница: 15 / 44

Installing the 58/86 disk drive enclosure: Details
The detailed installation procedure includes information from online references that are specified in the
overview. You can use the expanded instructions in this procedure to install your disk drive enclosure
into a rack and to cable it to a server.
Before you begin
v
This information is provided in printed form as a list of basic tasks for installing the 58/86 disk drive
enclosure. For the most current version, use the online information: Installing the 5886 disk drive
enclosure.
v
This procedure assumes that you are installing the 58/86 disk drive enclosure into an existing rack. If
the rack is not yet installed, you must first complete the procedure for Installing the rack.
v
Before installing the disk drive enclosure into a rack, read the Rack safety notices.
About this task
To install the 58/86 disk drive enclosure, complete the following tasks:
1. Unpack the disk drive enclosure as follows:
a. Refer to the kitting list provided with the rack installation kit, and complete a parts inventory.
b. Locate the rack-mounting hardware kit and the system rail assemblies that were included with
your disk drive enclosure.
The rails are front-to-back and left-to-right side dependent.
2. Determine where to install the disk drive enclosure into the rack as follows:
a.
Determine where in the rack to place the disk drive enclosure in relation to other system
hardware. As you plan, keep the following steps in mind:
1) Organize larger and heavier units into the lower part of the rack.
2) Plan to install units into the lower part of the rack first.
3) Record the EIA locations in your plan.
Note: The disk drive enclosure is two Electronic Industries Alliance (EIA) units high. An EIA unit
is 44.50 mm (1.75 in.) in height. The rack contains three mounting holes for each EIA unit of
height. This enclosure, therefore, is 89 mm (3.5 in.) high and covers 6 mounting holes in the rack.
b. If necessary, remove the filler panels to allow access to the inside of the rack enclosure where you
plan to place the disk drive enclosure.
3