Bull ESCALA PL860T/R, Процедуры снятия и замены, Страница: 41 / 218

Removing the disk drive
1.
From the IBM Power RAID Configuration Utility display, select Work with disk unit recovery . Press
Enter.
2. From the Work with Disk Unit Recovery display, select Concurrent remove device . Press Enter. A
Concurrent Device Remove display is shown, similar to the following display.
3.
Type option
1
(Select) next to the location for the disk drive you want to replace. Press Enter.
4. The Verify Device Concurrent Remove display is shown. The concurrent maintenance light turns on
for that disk drive slot.
5. On the Verify Device Concurrent Remove display, verify that the selected disk drive is the disk drive
you want to replace, then press Enter. The identify light turns on for the disk drive.
Attention: To prevent loss of data, ensure that the disk drive is not in use.
6. The Complete Device Concurrent Remove display is shown.
Concurrent Device Remove
Choose a single location for remove operations
1=Select
OPT Name PCI/SCSI Location Description Status
--- ------ -------------------------- ------------------------- -----------------
sdc 0000:41:01.0.1/0:8:0 Physical Disk Active
0000:41:01.0.1/0:5: Empty
sdb 0000:41:01.0.1/0:4:0 Physical Disk Active
sda 0000:41:01.0.1/0:3:0 Physical Disk Active
0000:41:01.0.1/1:8: Empty
sdf 0000:41:01.0.1/1:5:0 Physical Disk Active
sde 0000:41:01.0.1/1:4:0 Physical Disk Active
sdd 0000:41:01.0.1/1:3:0 Physical Disk Active
0001:61:01.0.2/0:8: Empty
sdh 0001:61:01.0.2/0:9:0 Physical Disk Active
sdg 0001:61:01.0.2/0:3:0 Physical Disk Active
Figure 4. Example Concurrent Device Remove display
Chapter 1. Removing and replacing FRUs
33