Bull Escala EL260B, Инструкция по установке и эксплуатации

Страница: 53 / 78

Chapter 3. Installing and removing options
37
6. Slide the blade server into the blade bay from which you removed it until the blade
server stops.
The spring-loaded doors farther back in the bay that cover the bay opening move out
of the way as you insert the blade server.
7. Push the release handles on the front of the blade server to close and lock them.
The discovery and initialization process can take up to three minutes to complete. The
discovery and initialization process is complete when the green LED stops flashing
rapidly and begins to flash slowly. At this point, you can power on the blade server
8. Turn on the blade server. See Turning on the blade server on page 14.
9. Verify that the power-on LED on the blade server control panel is lit continuously. The
continuous light indicates that the blade server is receiving power and is turned on.
Important:
Do not place any label on the blade server or in any way block the ventilation holes on the
blade server. See the documentation that comes with your Bull Blade Chassis for
information about label placement.
10. Use the SMS Utility program to configure the blade server. See Using the SMS utility
on page 43.
11. Also use the management module to configure the blade server. See the
documentation for the management module to understand the functions that the
management module provides.
If you have changed the configuration of the blade server or if this is a different blade
server than the one you removed, you must configure the blade server. You might also have
to install the blade server operating system.
See Chapter 5, Installing the operating system on page 49.
3.10 Input/output connectors and devices
The input/output connectors that are available to the blade server are supplied by the Bull
Blade Chassis.
See the documentation that comes with the Bull Blade Chassis for information about the
input/output connectors.
The blade server has a media-tray select button on the control panel. See Blade server
control panel buttons and LEDs on page 11 for information about this button and its
function.
The Ethernet controllers on the blade server communicate with the network through the
Ethernet-compatible I/O modules on the Bull Blade Chassis. Network signals to and from
the blade server or any expansion cards are automatically routed to a same-network-
interface I/O module through circuitry in the Bull Blade Chassis.