Bull Escala EL260B, Инструкция по установке и эксплуатации

Страница: 37 / 78

Chapter 3. Installing and removing options
21
3.2 Removing the blade server from a Bull Blade Chassis
Remove the blade server from the Bull Blade Chassis to access options, connectors, and
system-board indicators.
Figure 3-1. Removing the blade server from the Bull Blade Chassis
Attention:
• To maintain proper system cooling, do not operate the Bull Blade Chassis without a
blade server, expansion unit, or blade filler installed in each blade bay.
•
When you remove the blade server, note the bay number. Reinstalling a blade server
into a different bay from the one where it was removed might have unintended
consequences. Some configuration information and update options are established
according to bay numbers. If you reinstall the blade server into a different bay, you
might have to reconfigure the blade server.
Perform the following procedure to remove the blade server.
1.
Read “Safety” on page ix and the Installation guidelines on page 19.
2. If the blade server is operating, shut down the operating system.
3. Press the power-control button (behind the control-panel door) to turn off the blade
server. See Turning off the blade server on page 14.
4. Wait at least 30 seconds for the hard disk drive to stop spinning.
5. Open the two release handles as shown in the illustration. The blade server moves out
of the bay approximately 0.6 cm (0.25 inch).
6. Pull the blade server out of the bay. Spring-loaded doors farther back in the bay move
into place to cover the bay temporarily.
7. Carefully lay the blade server on a flat, static-protective surface, with the cover side
up.
8. Place either a blade filler or another blade server in the bay within 1 minute.
The recessed spring-loaded doors move out of the way as you insert the blade server
or filler blade.