Bull 296/C3, Руководство пользователя, Страница: 31 / 123

Bezels
The following procedures describe the removal and replacement of the system bezel. Before performing
the following procedures, read “Safety Notices” on page vii.
Removing the 296/C3 Front Bezel
To remove the front bezel, do the following:
1. Open the front rack door.
2. Press in on both bezel-release tabs at the same time.
3. Tip the bezel forward and gently pull the bezel up and away from the system.
1
2
3
4
1 296/C3 Front Bezel 3 Bezel-Release Tab
2 System-Retaining
Thumbscrew
4 System Drawer Release Latch
Replacing the 296/C3 Front Bezel
To replace the front bezel, do the following:
1. Open the rack front door.
2. Seat the two tabs located on the bottom edge of the bezel into their mating slots located on the bottom
edge of the system.
3. Pivot the bezel up, aligning the release tabs to the mating slots located on the front of the system.
4. Gently push the tabs into the slots until the bezel seats against the front of the system.
5. Close the front rack door.
Chapter 2. Removal, Replacement, and Installation Procedures
15