READ THE FOLLOWING INSTRUCTIONS AND WARNINGS TO AVOID SERIOUS INJURY
The BICS
®
is used as a protective measure against direct transfer of bodily fluids, such as
sneezing, coughing and breathing. The BICS
®
will greatly reduce the chance on infection, but does
not completely eliminate the chance of infection.
WARNING: Always pay attention to road and traffic conditions when driving.
WARNING: The BICS
®
may obstruct the view while driving. The BICS
®
may glint by light sources,
such as the sun, other cars lights as well as interior lights. Always make sure there is enough
visibility while driving.
WARNING: The BICS
®
is to be assembled by adults only.
Inflation: For best results, inflate by using a low pressure air pump (such as a Bicycle pump).
Remove the air valve cap and insert the appropriate attachment of your inflation device. Inflate the
tube to 100% capacity or until almost firm. Close air valve by attaching the cap.
WARNING: Do NOT over inflate tube, it may burst.
The BICS
®
is developed for use inside vehicles, without influence of wheather conditions and UV
light. The material of the BICS
®
is sensitive to UV-light and can slightly change color (yellowish). It
is important to only use the BICS
®
inside vehicles and that they are properly stored in a dry place
when not in use. The BICS
®
should not be exposed to UV radiation and wheather influences.
The BICS
®
can be cleaned and/or disinfected with most common cleaning agents up to a
concentration of 10 % at room temperature. Always ask the vendor of your BICS
®
screen whether
the cleaning agent and the concentration you have chosen is applicable to the material of the
BICS
®
! In case you use a cleaning agent, not applicable to the shield, it can irreversibly damage
the screen such that the visibility and transparency is reduced!. This can lead to dangerous traffic
situations!
When cleaning the BICS
®
inside the vehicle, be careful not to allow cleansing agent to leak into the
vehicle.
Part
2
>>
BICS
®
Vehicle screen instructions
Part 1
®