Buick Encore Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
9956106) - 2017 - crc - 10/20/16
Vehicle Care
227
4. Disconnect the wiring harness
connector from the bulb.
5. Install the new bulb in the
headlamp assembly by turning
clockwise.
6. Reconnect the wiring harness
connector.
7. Install the headlamp bulb
access cover.
For the driver side, reinstall the
windshield washer bottle filter
neck by firmly pushing it
straight into the bottle. Ensure
that the filter neck clip engages
into the underhood electrical
center retainer.
Uplevel Headlamp Assembly
The uplevel model vehicle has LED
high-beam and low-beam
headlamps, a turn signal lamp, a
parking lamp, a DRL, and
sidemarker lamp, and lamps on the
headlamp assembly.
Fog Lamps
Driver Side Shown, Passenger
Side Similar
1. Tilt the wheel and remove the
three Torx
®
screws on the
outside of the wheel liner.
2. Bend the wheel liner back to
make enough space for hand
access.
3. While holding the wheel liner
with one hand, remove the
lower cover, and disengage the
bulb socket from the plug
connector by pulling the
retaining rib.
4. Turn the bulb holder
counterclockwise and remove it
from the reflector using the
other hand.
5. Remove the bulb from the bulb
socket and replace with a
new bulb.
