Assembly
7
3.1
Electrical connection
For the electrical connection, carry out the following steps:
1. At the tank system, switch off the heater of the output to which the application head will
be connected.
2. At the controller/PLC, switch off the activation of the solenoid valve.
3. Connect the cable for activating the solenoid valve to the supplied plug and then con-
nect the plug to the solenoid valve and screw it in place.
4. Apply the free ends of the cable to the corresponding connections of the controller/
PLC.
5. Connect the plug-in connector at the end of the cable (5) to the mating connector at the
heatable hose.
Danger of burns!
If the heater is not switched off
(see step 1),
the application head can be heated now and
reach temperatures exceeding 200°C!
FCH0479-2XM_EN_191107.indd 7
07.11.19 14:03
