Buhler GAS 222 Series, Инструкция по установке и эксплуатации

Страница: 20 / 41

Bedienungs- und Installationsanleitung
Installation- and Operation Instruction
Gasentnahmesonden /
sample
gas
probe
Baureihe
/ Series
222.20-HT / 222.20-HT-OW-OR
20 BX460026, 01/2011 Art. Nr. 90 31 181
The following warning signs and signal words are used in this manual:
Warning against
hazardous situation
Warning against possible
explosive atmospheres
disconnect from
mains
Warning against
electrical voltage
Warning against hot
surface
wear respirator
Warning against
respiration of toxic gases
wear face protection
Warning against acid
and corrosive
substances
wear gloves
2.1 General Indication of Risk
Installation of the device shall be performed by trained staff only, familiar with the safety requirements and
risks.
Adhere to all relevant safety regulations and technical indications for the specific installation place. Prevent
failures and protect persons against injuries and the device against damage.
The person responsible for the system must secure that:
-
safety and operation instructions are accessible and followed,
-
local accident prevention regulations and standards are obeyed,
-
performance data and installation specifications are regarded,
-
safety devices are installed and recommended maintenance is performed,
-
national regulations for disposal of electrical equipment are obeyed.
Maintenance and repair
-
Repairs on the device must be carried out by Bühler authorized persons only.
-
Only perform modifications, maintenance or mounting described in this manual.
-
Only use original spare parts.
During maintenance regard all safety regulations and internal operation instructions.
DANGER
Electrical voltage
Electrocution hazard.
Before opening the cover or working on electrical components, disconnect the
device from power supply. Make sure that the equipment cannot be
reconnected to mains unintentionally.
Installation and maintenance must be carried out by trained staff only. Regard
correct mains supply.